Navigation:  Centralized Administration > Virtual Printer Driver (VPD) > Administration > Print Templates > Cutting Function > Zebra Printer (Last update of this topic: 04-16-2025)

Depending on the printer model, the cutting function for Zebra devices can be activated via the driver. In this case, the point is that a job contains several documents or labels and finally the labels attached to each other are to be cut. The standard version only includes cutting after each label. However, the function can be realized via a VPD print template of type protected using the activated setting Zebra printer: Enable Zebra Delayed Cut (see figure: steadyPRINT: Create print template for Zebra label printer).

 

Figure 55: steadyPRINT: Create print template for Zebra label printer

 

In the driver settings for the VPD print template the following settings must be set (see figure: steadyPRINT: Create printer settings for Zebra label printer).

 

Figure 56: steadyPRINT: Create printer settings for Zebra label printer